Land Pride rcf3696 Brush Cutter User Manual


 
50
Section 5: Maintenance & Lubrication
RCF3696, RCFM3696, RCF3610, & RCFM3610 Rotary Cutters 326-600M
12/15/15
Table of Contents
T-Gearbox
Check oil level in gearbox by removing lower rear plug in
gearbox case. If oil is below lower rear plug hole, add
recommended gear lube through top plug hole until oil
flows out of lower rear plug hole. Reinstall oil plugs and
tighten.
Type of Lubrication: 80-90W EP Oil
Quantity = Fill until oil flow from upper rear port of
gearbox case.
NOTE: Do not overfill! Cutter should be level when
checking oil.
8
Hrs
Gearbox
Method 1: Unscrew top vented dipstick (#1). Wipe oil
from dipstick and screw dipstick in without tightening.
Unscrew dipstick and check oil on dipstick. If below
bottom level mark, add recommended gear lube through
dipstick hole until oil reaches top mark on dipstick.
Reinstall vented dipstick and tighten.
Method 2: Remove side oil plug (#2). If oil is below
bottom of plug hole, add recommended gear lube
through top dipstick hole until oil flows out of side plug
hole. Reinstall and tighten side oil plug (#2) and vented
dipstick (#1).
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil reaches top mark on dipstick or
begins to flow out side plug hole in gearbox.
NOTE: Do not overfill! Cutter should be level when
checking oil. Oil expands when hot, therefore, always
check oil level when cold.
8
Hrs.
30215
Do Not Overfill
IMPORTANT: Your cutter is shipped with a vented
dipstick packaged in the Operator’s Manual bag and
should have been installed in the gearbox by your
Land Pride dealer. Please see your Land Pride dealer
if vented dipstick was not included.
NOTE: Use a suction or siphon pump to drain
gearboxes of oil when there is not an oil drain plug.
33419
Do Not Overfill
IMPORTANT: Your cutter is shipped with a vented
dipstick packaged in the Operator’s Manual bag and
should have been installed in the gearbox by your
Land Pride dealer. Please see your Land Pride dealer
if vented dipstick was not included.
NOTE: Use a suction or siphon pump to drain
gearboxes of oil when there is not an oil drain plug.
35008
RCF(M)3610 Flex Coupler
Type of Lubrication: Multi-Purpose Grease
Quantity = As required
8
Hours