Filter
Top Products
17
Section 1: Assembly & Set-Up
12/15/15
RCF3696, RCFM3696, RCF3610, & RCFM3610 Rotary Cutters 326-600M
Table of Contents
Semi-Mount Assembly & Set-Up
The following pages are Assembly & Set-Up Instructions
for Semi-Mount cutters. See “3-Point Assembly & Set-
Up” on page 12 and “Pull-Type Assembly & Set-Up” on
page 22.
Spring Hose Loop Assembly
Refer to Figure 1-12:
1. Attach mounting bracket (#1) with 3/4"-10 x 1 1/2"
GR5 cap screw (#3) and lock nut (#4) to the right-
hand clevis as shown. Tighten nut to the correct
torque.
2. Attach spring hose loop (#6) to mounting bracket (#1)
with 3/8"-16 x 1" GR5 cap screw (#2), flat
washer (#5), and lock nut (#4). Tighten nut to the
correct torque.
Spring Hose Loop Assembly
Figure 1-12
35006
RCF(M)3696 Tailwheel Assembly
Refer to Figure 1-11:
1. There are several cylinder mounting lugs (#3) that
can be installed on axle (#2). Refer to NOTES IN
BOLD in Figure 1-11 to make sure your cutter is
equipped with the correct mounting lug and that the
notch in the lug is located on the axle properly. See
your nearest Land Pride dealer if it is not correct.
2. Install washers (#5) as follows:
RCF(M)3696 With 15" Tailwheels
• Install two 2 1/4" O.D. machine washers (#5) onto
each tailwheel spindle (#7).
RCF(M)3696 With 21" Tailwheels
• Install one special 4" O.D. harden washer (#5) onto
each tailwheel spindle (#7).
3. Insert tailwheel spindle (#7) into pivot tube on end of
tailwheel arm (#1).
4. Install 2 1/4" O.D. machine washers (#5) over each
tailwheel spindle (#7) and secure with 3/8" x 2 1/2"
roll pins (#6).
5. Tail wheel arms (#1) should be adjusted to customer
preference. When completed, they should be equal
distance from center line of hydraulic lift cylinder.
a. Loosen hex flange lock nuts (#4) and adjust
tailwheel arms (#1) in or out to desired locations.
b. Retighten lock nuts (#4) to the correct torque.
NOTE: If preferred, rear guards may be assembled
before the tailwheels. See “Assembly of Optional
Equipment” on page 28 for rear guard instructions.
35027
RCF(M)3696 Model With 15" Tailwheel Assembly
33948
RCF(M)3696 Model With 21" Tailwheel Assembly
RCF(M)3696 Semi-Mount Tailwheel Assembles
Figure 1-11