Filter
Top Products
18
Section 1: Assembly & Set-Up
RCF3696, RCFM3696, RCF3610, & RCFM3610 Rotary Cutters 326-600M
12/15/15
Table of Contents
RCF(M)3610 Tailwheel Assembly
Refer to Figure 1-13:
1. There are several cylinder mounting lugs (#5) that
can be installed on axle (#1). Refer to NOTES IN
BOLD in Figure 1-13 to make sure your cutter is
equipped with the correct mounting lug and that the
notch in the lug is located on the axle properly. See
your nearest Land Pride dealer if it is not correct.
2. Attach left and right-hand tailwheel arms (#2) to axle
tube (#1) with 5/8"-11 U-bolts (#4) and hex flange
lock nuts (#3). Do not tighten lock nuts.
3. Adjust tailwheel arms to desired locations and
tighten lock nuts (#3) to the correct torque. When
completed, the tailwheel arms should be equal
distance from center line of hydraulic lift cylinder.
NOTE: If preferred, rear guards may be assembled
before the tailwheels. See “Assembly of Optional
Equipment” on page 28 for rear guard instructions.
35026
RCF(M)3610 Model With 15" Tailwheel Assembly
35024
RCF(M)3610 Model With 21" Tailwheel Assembly
RCF(M)3610 Semi-Mount Tailwheel Assembles
Figure 1-13