Filter
Top Products
3 - 2 92B/96B/99B/105B Users Manual
MAKING CONNECTIONS
ScopeMeter test tool measurement connections are
illustrated in Figure 3-1.
Use the red INPUT A BNC jack or the red and black 4 mm
banana jacks for measurements. The ScopeMeter test tool
informs you when to use INPUT A or the banana jacks.
The red 4-mm banana jack is used for diode test, continuity
test, Ohm measurement, and when you use a Current or
Temperature probe with banana jacks.
When you use the PM8918 probe, select the 10:1 probe
type for correct decimal readout.
WARNING
To prevent electric shock and personal injury, Mini Test
Hooks and HF Adapters must not be connected to any
voltage higher than 42V peak (30V rms) to earth.
Always pay attention to the markings on the
accessories.
Figure 3-1. Measurement Connections