Fluke 99B Telescope User Manual


 
6 - 20 92B/96B/99B/105B Users Manual
Setting the Date
You can set the date as follows:
1. From the User Options menu, press (DATE AND
TIME) to open the Date and Time menu.
2. Press (SET DATE) to open the date menu.
3. To change the month, press (SET MONTH). The
date progresses one month per key press. Hold down
to speed up this progression.
4. To change the day, press (SET DAY). The date
progresses one day per key press. Hold down to
speed up this progression.
5. To change the year, press (SET YEAR). The year
progresses one year per key press. Hold down to
speed up this progression.
6. To change the day format, press . You can choose
between the following:
mm-dd-yy (month, day, year) e.g. 02-26-1996
dd-mm-yy (day, month, year) e.g. 26-02-1996
7. Press, (CLOSE) twice to accept the new date and
date format.
CHANGING THE RESET CONFIGURATIONS
When you turn the test tool on, it begins operation in the
last-known configuration, and the main SCOPEMETER
function menu appears. Subsequent power-ons maintain
configuration changes made with keystrokes or through
recall of a setup memory during the previous session.
Default settings are used at the first power-on or after a
reset. You can reset the test tool at any time. The
ScopeMeter test tool can be reset in the following way:
- Master Reset ( + ). A definition of Master
Reset is given below.
- Reset + . Same as Master Reset, but does
not clear the memories.
CAUTION
A Master Reset clears all Screen, Waveform, and Setup
memories.
The Master Reset includes the following settings:
Meter Mode
Three Readings for Meter Mode, and two Readings for
Scope Mode
Autoranging
Backlight On
Probe Scaling 10:1
All Memories Cleared
Generator Off
Print Format Screen
Printer Setup FX/LQ Graph, 1200 Baud