Filter
Top Products
PROGRAMMING AND OPERATION
30
Operation of Buttons (Continued)
Pump Button
(This button is not active if the Set Relay 1 is programmed for “Acid Pump” or “Relay not used”. If the Pump button is pressed
when programmed for one of these modes, ”
Acid Pump” or ”Relay 1 not used” will display, then revert back to the normal
display.)
Pump Button – One-speed pump control - The Pool Pilot must be wired to control the main circulation pump and programmed for
a One-speed pump for this feature to be active (see pg. 34).
With “PUMP ON”, to turn “PUMP OFF”;
1. Press PUMP.
2. “
∇ - Stop Pump” will be displayed. Press ∇.
3. “
pump off” will be displayed.
With “PUMP OFF”, to turn “PUMP OFF FOR SERVICE” -
(This mode disables Pump operation indefinitely, until manually enabled. Boost and Pump program modes will not enable
pump.)
1. Display indicates “
pump off”.
2. Press PUMP.
3. Press
∇ - Maintenance
4. “PUMP OFF FOR SERVICE” and a Red
CHECK SYSTEM light will now be displayed.
With “PUMP OFF FOR SERVICE”, to terminate maintenance mode and return to “PUMP OFF”.
1. Press PUMP.
2. Press
∆ - End Maint.
3. Pump will be in the “
pump off” status.
With “PUMP OFF”, to turn “PUMP ON”.
1. Press PUMP.
2. Press
∆ - Start Pump
3. The pump will run until the pump program reaches the next scheduled turn off time
Pump Button – Two-speed pump control
- The Pool Pilot must be wired to control a two-speed main circulation pump and
programmed for Two-speed pump for this feature to be active. The Pool Pilot cannot turn off the pump, and can only change
pump speeds, betwee n high and low (See pg . 34).
With pump on “HIGH SPEED”, to switch to “LOW SPEED”.
1. Press PUMP.
2. Press
∇ - Low Speed
3. Pump will switch to low speed.
With pump on “LOW SPEED”, to switch to “HIGH SPEED”.
1. Press PUMP.
2. Press
∆ - High Speed
3. Pump will switch to high speed.