Filter
Top Products
PROGRAMMING AND OPERATION
26
Basic Programming
Control Panel Features and Functions
The first line of the display typically indicates the Purifier Output Level
in percent (%), or whether the system is in Boost or Super-Boost mode. The
second line displays the current time of day in 12- or 24-hr mode,
the temperature in Fahrenheit or Celsius, and purifier on/off mode. A small dot in
the bottom right corner indicates the self-cleaning forward/reverse cycle.
In pH mode, display will toggle between Purifier display to the pH Feed
display (then the Acid Meter but only when the acid pump is actually
feeding).
In TC mode, display will toggle between normal display, ORP
measurement (set point), and pH measurement (set point)
Check system – Red LED flashes
to warn that attention is needed. A
warning message will also be
displayed.
Press the Up or Down
Arrow to:
• Set Chlorine
Level % (and
ORP/pH levels
when optional
Digital TC
components are
installed)
• Scroll through
Menus and sub-
Menus
• Increase or
Decrease
programming
values for menus
Press the Pump button to
manually override a stored
program for:
• Turning the pump on, off,
or off for maintenance.
• Changing the speed of a 2-
speed pump.
Not applicable if the Set Relay 1
is programmed for
“Acid
Pump”
or “Relay not used”.
Press Boost to start 24-
hour boost mode, o r
press and hold Boost for
8 seconds to start 72-
hour boost mode. Press
Boost again to cancel
boost.
Press Menu to leave normal operation
to access the menus for programming
and diagnostics
Press the Select button
to choose the item on the
display
P u r i f i e r 5 0 %
4:21 P 82F ON
.
Pool Pilot
™
Check
System
Boost Menu Select Pump