Using Key Operator Settings
179
9
r Deleting a destination specified as
an end receiver from the Address
Book causes the settings for the
end receiver to be deleted. If this is
the case, reprogram the end receiv-
er. If the destination has been
changed, a message is transmitted
to the new destination.
A Press the {User Tools/Counter} key.
B Press [Facsimile Features].
C Press [Key Operator Tools].
D Press [Box Setting].
E Select a box to program.
When programming a new box,
press [*Not Programed].
Note
r To change a box already pro-
grammed, press it, and then
proceed to step .
F Press [Transfer Box].
G Enter a Box name, and then press
[OK].
Reference
“Entering Text”, General Set-
tings Guide
H Enter a SUB Code.
Note
r To change the SUB Code, press
[Clear] or the {Clear/Stop} key,
and then try again. To change
Box name, press [Box Name], and
then repeat from step .
I Specify the condition of registra-
tion.
Programming End Receivers
A Select an End Receiver.
Note
r You can store five End Re-
ceivers.
B Specify End Receivers with
Quick Dials, and then press
[OK].
Note
r You can also specify End Re-
ceivers with Group Dials.
Note
r Repeat from step A to speci-
fy another End Receiver.
