Using Key Operator Settings
171
9
Note
r You can specify a horizontal
size from 148 mm (5.9 inch)
to 600 mm (23.7 inch). You
cannot enter a size smaller
than 148 mm or larger than
600 mm.
r Each time you press [mm] or
[inch], the units switch be-
tween “mm” and “inch”. If
you enter a length and
change the units by pressing
[mm] or [inch], it is converted
automatically (fractions are
rounded off).
G Press [OK].
G Press [Exit].
H Press the {User Tools/Counter} key.
The standby display appears.
Deleting a Special Sender
Use this function to program “Initial
Set Up” of a Special Sender. The By-
pass Tray Paper Size can also be spec-
ified.
A Press the {User Tools/Counter} key.
B Press [Facsimile Features].
C Press [Key Operator Tools].
D Press [Program Special Sender].
E Press [Delete], and then select the
Special Sender you want to de-
lete.
F Press [Delete].
Note
r To cancel deleting a special
sender, press [Do not Delete]. The
display returns to that of step
E
.
G Press [Exit].
H Press the {User Tools/Counter} key.
The standby display appears.
Printing the Special Sender List
A Press the {User Tools/Counter} key.
B Press [Facsimile Features].
C Press [Key Operator Tools].
D Press [Print List] next to “Program
Special Sender”.
Note
r To cancel printing, press [Can-
cel]. The display returns to that
of step
D
.
E Press the {Start} key.
Note
r To cancel printing after press-
ing the {Start} key, press [Stop
Printing]. The display returns to
that of step
D
.
F Press the {User Tools/Counter} key.
The standby display appears.
