A SERVICE OF

logo

Open as PDF
next previous
138 Summit Radio
VX7 Reference Guide E-EQ-VX7RG-D
LEAP without WPA Authentication
To use LEAP (without WPA) make sure the following profile options are used:
• Enter the SSID of the Access Point assigned to this profile
• Set EAP Type to LEAP
• Set Encryption to Auto WEP
• Set Auth Type as follows:
o If the Cisco/CCX certified AP is configured for open authentication, set the
Auth Type radio parameter to “Open”.
o If the AP is configured for network EAP only, set the Auth Type radio
parameter to “LEAP”.
Please see “WPA/LEAP” later in this section to configure the radio for WPA LEAP.
Figure 5-12 LEAP Configuration