Filter
Top Products
Starting the Inverter
4–4 975-0320-01-01
If the inverter stops operating after the input current has risen above 1 A, turn
the unit off, remove DC power, and have a certified electrician or technician
inspect the ground fault protection fuse. If the fuse has blown, a DC wiring
problem may exist. Check all DC wiring to ensure that the unit is connected to
a single PV array.
5. Proceed to the next inverter and perform the same test. See Figure 4-2 for an
example of the recommended commissioning sequence.
Figure 4-2
Commissioning Sequence for Multiple Inverters
1
2
3