Filter
Top Products
Operation
4–4 975-0082-01-01
3. Use the up or down arrow button to select the minute, then press
Enter.
If you are using the 24-hour clock, go to step 5.
4. Use the up or down arrow button to select AM or PM, then press
Enter.
5. Press Exit twice to return to the System screen.
Setting the end of Quiet Time
Setting a time for “QT End” defines the end of Quiet Time. At the time
you set for “QT End”, the Auto Gen Start will be able to start the
generator when an automatic start trigger (such as low battery voltage or a
high inverter load) occurs in the Xanbus system. If there is an automatic
start trigger already active in the system when Quiet Time ends, the
generator will start immediately.
To set the end of Quiet Time:
1. On the Auto Gen Start menu, use the up or down arrow buttons to
highlight “QT End”, then press Enter.
2. Use the up or down arrow button to select the hour, then press Enter.
3. Use the up or down arrow button to select the minute, then press
Enter.
If you are using the 24-hour clock, go to step 5.
4. Use the up or down arrow button to select AM or PM, then press
Enter.
5. Press Exit twice to return to the System screen.