Filter
Top Products
Linear Actuator Replacement (Fig. 28)
1. Put wheels in transport position (machine raised).
2. Put the machine on a level surface, stop the engine,
engage the parking brake and disconnect engine spark
plug wires.
3. Open the hood.
4. Disconnect linear actuator wire connector.
5. Disconnect extension springs.
6. Remove capscrew and nut securing each end of
linear actuator.
Figure 28
1
2
4
4
3
7. Reverse steps 3 - 6 to install the linear actuator.
1. Linear actuator 3. Extension spring
2. Wire connector 4. Capscrew & nut
Hydroject 3010 Page 5 - 27 Repairs