Filter
Top Products
Special Tools
NOTE: Order special tools from the TORO SPECIAL
TOOLS AND APPLICATIONS GUIDE (COMMERCIAL
PRODUCTS). Some tools may be listed in the
Hydroject 3010 Parts Catalog. Some tools may also be
available from a local supplier.
Hydraulic Tester - With Pressure and Flow Capabilities (Fig. 9)
Outlet
Hose
Flow Meter
Gauge
Inlet Hose
Gauge
Low Pressure
Gauge
Load Valve
High Pressure
Protector Valve
Figure 9
You must have o-ring face seal (ORFS) adapter fittings
for this tester to use it on the HydroJect 3010.
1. INLET HOSE: Hose connected from the system
circuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: If required, upon turning the valve to
restrict flow, a simulated working load is created in the
circuit.
3. LOW PRESSURE GAUGE: Low range gauge to
provide accurate reading at low pressure, 0 - 1000 psi.
This gauge has a protector valve which cuts out
when pressure is about to exceed the normal range
for the gauge. The cutout pressure is adjustable.
4. HIGH PRESSURE GAUGE: High range gauge to
accommodate pressure beyond the capacity of the low
pressure gauge, 0 - 5000.
5. FLOW METER: This meter measures actual oil flow
in the operation circuit, with a gauge rated at 15 GPM.
6. OUTLET HOSE: Hose from the outlet side of the
hydraulic tester to be connected to the hydraulic system
circuit.
Hydroject 3010 Page 4 - 7 Special Tools