Filter
Top Products
Pushing or Towing (Fig. 7)
The machine can be pushed or towed for very short
distances with the engine off, if necessary.
IMPORTANT: Do not push or tow the machine faster
than 5 MPH because the hydraulic pump may be
damaged. If the machine must be moved further
than a few feet, transport it on a trailer or pull with
traction wheel raised and secured to a dolly. When-
ever the machine is pushed or towed, the by-pass
valve must be open. Hook on front of handle is used
for a tie-down only, not a hitch point.
1. Stop the engine and raise the hood.
2. Open the by-pass valve by turning it counterclockwise
(2 turns maximum).
3. After moving the machine, close the by-pass valve by
turning it clockwise. Tighten the by-pass valve to a
torque of 7 to 10 ft-lb.
IMPORTANT: Operating the machine with the by-
pass valve open will cause improper operation and
overheating of the hydraulic system.
1
Figure 7
1. By-pass valve
Hydroject 3010 Page 4 - 5 General Information