Filter
Top Products
GroundsmasterR3000–D Maintenance Schedule
Minimum Recommended Maintenance Intervals
Lubricate All Grease Fittings
Inspect Air Filter
Check Battery Level/Cable Connections
Check Cutting Unit Gearbox Oil Level
Clean Under Cutting Unit Belt Covers
Check Cutting Unit Drive Belt Adjustment
} Change Engine Oil and Filter
Inspect Cooling System Hoses
{
{
Service Air Filter
Change Fuel Filter
Inspect Fuel Lines and Connections
} Check Engine RPM (idle and full throttle)
Check Rear Axle Oil Level (4wd)
Change Cutting Unit Gearbox Oil
= Change Rear Axle Oil (4wd)
= Change Hydraulic Oil (see note below)
= Change Hydraulic Oil Filter (see note below)
Inspect Engine Timing Belt (see note below)
Pack 2WD Rear Axle Bearings
{ Initial break in at 10 hours
} Initial break in at 50 hours
= Initial break in at 200 hours
Replace Moving Hoses
Replace Safety Switches
Cooling System Flush/Replace Fluid
Every
50hrs
Every
100hrs
Every
200hrs
Annual Recommendations:
Items listed are recommended every 1500
hours or 2 years, whichever occurs first.
Every
400hrs
Every
800 hrs
A Level
Service
B Level
Service
C Level
Service
D Level
Service
E Level
Service
Check Fan and Alternator Belt Tension
Torque Wheel Lug Nuts
Drain and Clean Fuel Tank
Check Rear Wheel Toe–In
Maintenance Procedure Maintenance Interval & Service
(See Operator’s Manual for specifications and procedures.)
NOTE: Replace Timing Belt after every 1500 hours of operation or if worn, cracked, oil soaked or
any time the Belt is removed or loosened.
NOTE: Replace Hydraulic Oil and Filter every 400 hours of operation if machine is equipped with
Model 30726 Auxiliary Hydraulic Kit.
Product Records and Maintenance
Page 2 – 14
Rev. B
Groundsmaster 3000/3000–D