Filter
Top Products
Performance Verification
AWG510 & AWG520 Service Manual
4-13
STOP. These procedures extend the confidence level provided by the basic
procedures described on page 4–3. The basic procedures should be done first,
then these procedures performed if desired.
The tests in this section comprise an extensive, valid confirmation of perfor-
mance and functionality when the following requirements are met:
H The cabinet must be installed on the instrument.
H You must have performed and passed the procedures under Self Tests, found
on page 4–3.
H The waveform generator must have been last adjusted at an ambient
temperature between +20_ C and +30_ C, must have been operating for a
warm-up period of at least 20 minutes, and must be operating at an ambient
temperature between +10_ C and +40_ C.
Read Conventions on page 4–1.
These procedures use external, traceable signal sources to directly check
warranted characteristics. The required equipment list follows this introduction.
Table 4-5: Test equipments
Item number and
description
Minimum requirements Example (recommended) Purpose
1. Frequency Counter 1 MHz to 100 MHz,
Accuracy: t 0.2 ppm
Anritu MF1603A Used to check reference input
test.
2. Digital multi meter DC volts range: 0.05 V to 10 V,
Accuracy: "0.1 %
Fluke 8842A Used to check to measure
voltage.
3. Oscilloscope Bandwidth: u 500 MHz, 1 MW and
50 W inputs
Tektronix TDS784C Checks output signals. Used
in many procedures.
4. Oscilloscope Bandwidth: u 1 GHz,
Rise time: t 350 ps, 50 W input
Tektronix TDS820 Checks direct DA rise time.
5. Spectrum Analizer 1 KHz to 1 GHz Tektronix 497P or
Advantest R4131
Checks output signals.
6. Function Generator Output voltage: -5 V to +5 V,
Frequency accuracy: t 0.01 %
Tektronix AFG310 Generates external input
signals. Used in many input
signal test procedures.
7. Signal Generator Output voltage: u 0.25 V
p-p
,
Frequency: u 1 GHz
HP 8648x , x: B or D Used to check external clock
input.
8. BNC Coaxial Cable
(3 required)
50 W, male to male BNC connectors Tektronix part number
012Ć0482Ć00
Signal interconnection
Prerequisites
Related Information
Equipment Required