Filter
Top Products
Removal and Installation Procedures
6-10
AWG510 & AWG520 Service Manual
Section 10 lists all modules.
STOP. READ THESE GENERAL INSTRUCTIONS BEFORE REMOVING A
MODULE.
First read over the Summary of Procedures that follows to understand how the
procedures are grouped. Then read Equipment Required for a list of the tools
needed to remove and install modules in this waveform generator.
If you are removing a module for service, begin by doing the Access Procedure
procedure on page 6–16. By following the instructions in that procedure, you
remove the module to be serviced while removing the minimum number of
additional modules.
The procedures are described in the order in which they appear in this section. In
addition, you can look up any procedure for removal and reinstallation of any
module in the Table of Contents of this manual.
H The Access Procedure on page 6–16 first directs you to the procedure(s) (if
any) that are required to access the module to be serviced, then it directs you
to the procedure to remove that module.
H Procedures for External Modules on page 6–17 are procedures for removing
modules that do not require internal access to the generator.
H Procedures for Outer-Chassis Modules on page 6–30 are procedures for
removing modules the removal of which require access internal to the
instrument but external to the chassis.
H Procedures for Inner-Chassis Modules on page 6–44 are procedures for
removing modules the removal of which require access internal to the
instrument and internal to the chassis.
List of Modules
General Instructions
Summary of Procedures