Filter
Top Products
Removal and Installation Procedures
6-48
AWG510 & AWG520 Service Manual
6. Remove the LAN Board:
a. Using a screwdriver with a size Phillips #2 tip, remove the screw on the
left side of the LAN board. See Figure 6–22, page 6–45.
b. Grasp the board and slide it out.
7. Remove the A30 GPIB Board:
a. Using a screwdriver with a size Phillips #2 tip, remove the screw on the
left side of the GPIB board. See Figure 6–22, page 6–45.
b. Grasp the board and slide it out.
8. Remove the Back Plane:
a. Using a screwdriver with a size Phillips #2 tip, remove the four screws
securing the board to the frame. See Figure 6–22, page 6–45.
b. Grasp the board and slide it out.
9. Reinstallation:
a. Do, in reverse order, steps 4 through 8, reversing each step to reinstall all
boards in the CPU Unit.
b. Do, in reverse order, substeps 3a through 3c, reversing each step to
reinstall the CPU Unit.
c. Refer to the following procedures, in order, to complete reassembly of
the waveform generator.
H A10/A11 Connector Board (cables only, page 6–34)
H Cabinet (page 6–20)