Filter
Top Products
Removal and Installation Procedures
6-36
AWG510 & AWG520 Service Manual
3. Remove the A60 Memory Board.
a. Release the retainer latches securing the memory boards to the A50
AWG board. See Figure 6–16. Using the tweezers, pinch the tab of the
retainer out of the hole of the memory board. Then, insert the tweezers’
tip into the hole of the retainer to slide it out.
b. Open the lever on one side of the connector, and lift out the memory
board.
c. Repeat 3a and 3b to remove the other memory boards.
Figure 6-16: A60 Memory Board removal
4. Reinstallation: Do substeps 3b then 3a reversing each step to reinstall each
memory board.