Filter
Top Products
Removal and Installation Procedures
AWG510 & AWG520 Service Manual
6-33
3. Remove the low–voltage power supply:
a. Unplug three power cables from J1, J2, and J3 (on the A10/A11
Connector board). See Figure 6–14.
b. Remove the two screws from the rear of the generator that mount the
low-voltage power supply to the rear chassis.
c. Remove the four screws from the top of the generator that mount the
supply to the main chassis. Then remove the screw securing the ground
lead to the main chassis.
d. Lift the module up out of the generator to complete removal.
J1
J2
J3
Figure 6-14: Power supply module removal