Filter
Top Products
AWG510 & AWG520 Service Manual
6-9
Removal and Installation Procedures
This subsection contains procedures for removal and installation of all mechani-
cal and electrical modules. Any electrical or mechanical module, assembly, or
part listed in Section 10 of this manual is a module.
Preparation Ċ Please Read
WARNING. Before doing this or any other procedure in this manual, read the
Safety Summary found at the beginning of this manual. Also, to prevent possible
injury to service personnel or damage to this generator’s components, read
Installation in Section 2, and Preventing ESD in this section.
This subsection contains the following items:
H This preparatory information that you need to properly do the procedures
that follow.
H List of tools required to remove and disassemble all modules.
H Three module locator diagrams for finding the External Modules (see
Figure 6–2), Outer-Chassis Modules (see Figure 6–3), and Inner-Chassis
Modules (see Figure 6–4) in this generator.
H Procedures for removal and reinstallation of the electrical and mechanical
modules.
H A disassembly procedure for removal of all the major modules from the
generator at one time and for reassembly of those modules. A complete
disassembly is normally only done when completely cleaning the generator.
(Instructions for doing the actual cleaning are found under Inspection and
Cleaning at the beginning of this section.)
H Module disassembly procedures.
WARNING. Before doing any procedure in this subsection, disconnect the power
cord from the line voltage source. Failure to do so could cause serious injury or
death.