Filter
Top Products
435/485/535
3-45
AD-12
SPEED
PTO RPM
AREA
START
STOP
CAL
DIST
% SLIP
DISTANCE
SELECT
AD-11
SPEED
PTO RPM
AREA
START
STOP
CAL
DIST
% SLIP
DISTANCE
SELECT
ON
AD-13
SPEED
PTO RPM
AREA
START
STOP
METERS
% SLIP
DISTANCE
SELECT
Section 3 - Operation
EIC - Calibration
1
1
2
2
3
9. As the tractor crosses the “Finish Line” touch the
SELECT button (1) once. The TPM will display
“DIST CAL 2”.
10. Touch select button (1) again to save the
calibration. The TPM will display “DIST CAL 3”.
11. Touch start/stop button (2) twice to exit mode 20.
12. Drive the tractor around and stop 10 m before the
finish line.
Distance check
1. Touch the distance button (3) once. If the TPM does
not display “0 meters or feet” hold the start/stop
button (2) for 2 seconds to clear the display.
2. Select a low gear and drive the tractor forward.
3. As the tractor crosses the “Finish Line” touch
the start/stop (2) button once. The TPM will begin
accumulating distance traveled
4. Continue driving until the tractor reaches the “Start
Line”.
5. As the tractor crosses the “Start Line” touch
the start/stop (2) button once. The TPM should show
approximately 100 m (+/- 5 m), (328 ft (+/- 15 ft).
If not, re-run distance check.