Filter
Top Products
435/485/535
4-59
Section 4 - Lubrication & Maintenance
As Required
F4-91
F4-92
Operation 79
Check the Windshield Washer Fluid
The front and (rear-optional) windscreen washers are
fed from a single reservoir located behind the right
hand fuel tank.
Remove the lid (1) on the reservoir and add fluid as
necessary.
Operation 80
Change the Windshield Wiper Blades
The front and rear windshield wiper blades can be
changed using the following procedure:
Pivot the wiper arm outward away from the window.
Remove the blade bolt (2) from the center of the
blade. Install the new blade and reinstall the center
bolt.
The front and rear windshield wiper blade is 713 mm
(28") long.
Replacement wiper blade (front & rear)
P/N: 86032440
Operation 81
Clean the Cab Floor
Keep the cab floor free of dirt and debris that may
cause an obstruction or safety hazard, especially
around the brake and clutch pedal area.
The cab floor should be kept clean by periodically
vacuuming or sweeping, and washing.
The floor mat can be removed from the cab floor by
rolling it away from the walls of the cab and pulling
it upward and away from the floor. The floor mat is a
two-piece rubber mat that can be washed using a mild
detergent.
Operation 82
Clean the Cab Seat and Upholstery
When the soft trim material and seat become dirty,
they should be wiped clean. Dip a cloth in a warm
water/detergent solution and wring out as much of the
water as possible. Wipe the interior material with the
damp cloth.
The interior molding inside the cab can be cleaned
with a water/detergent solution as needed.
2
1