Filter
Top Products
435/485/535
3-43
F3-61
SPEED
PTO RPM
AREA
START
STOP
% SLIP
DISTANCE
SELECT
1
6
F3-121
SPEED
PTO RPM
AREA
START
STOP
GAL CAL
FT
% SLIP
DISTANCE
SELECT
4
1
2
4
F3-124
SPEED
PTO RPM
AREA
START
STOP
CAL
% SLIP
DISTANCE
SELECT
AREA
1
2
3
4
5
Section 3 - Operation
EIC - Calibration
4. Setting the area preset
The area accumulator calculates the total area covered
by the tractor. The accumulated area is stored in the
area preset when the tractor is switched off. When the
tractor is started again, area accumulation starts from
the stored preset.
1. To modify the area preset, enter the desired area.
The selected (flashing) digit (3) can be changed by
touching the UP and DOWN arrow
buttons (4) . Other
digits may be selected by touching the LEFT and
RIGHT arrow
buttons (5).
2. The area preset may be cleared by holding the
START/STOP
button (2) for two seconds.
3. Once the desired area preset has been entered,
touch the SELECT
button (1) to confirm the change.
5. Turning active fault display on/off
Whenever a fault is detected by the electrical system,
a fault code is stored in the EIC memory, and the
flashing book icon appears in the TPM display. If
active fault display is turned on the fault code will also
be displayed as a flashing number in the TPM.
1. To toggle active fault display, touch the UP and
DOWN arrow
button (4). When active fault display
is on, the display will show “ON” (6) and fault
code. When active fault display is off, the display
will only show “OFF”.
2. Touch the SELECT
button (1) to confirm the
change.
6. Selecting between Imperial and Metric units
The EIC can display measurements in either English
(Imperial) units, or in Metric units.
1. To select the desired display units, touch the UP
and DOWN arrow
buttons (4). When English units are
selected, the display will show “˚F”, “GAL”, and
“FT”. When Metric units are selected, the display
will show “˚C”, “L”, and “METERS”.
2. Touch the SELECT
button (1) to confirm the
change.
To exit Mode 1
Touch the START/STOP button (2) to return to
the calibration menu. Touch the START/STOP
button (2) again to return to normal operation.