Filter
Top Products
3-32
435/485/535
F3-40
F3-39
Fuel Level
The inside right bar graph (3) indicates fuel level.
Each segment of the bar graph display represents
one-twentieth (approximately 5 percent) of the total
fuel content of the tank.
When the fuel level falls so that only two segments of
the bar graph are displayed, the bar graph will flash
continually and the non-critical alarm will sound for
one second.
The system also has a feature to assist the operator
during refueling procedures. An audible indicator
alerts the operator when the tanks are filled to 3/4
capacity (15 bars) and 19/20 or 95% (19 bars).
NOTE: This feature only operates when the ignition
switch is set to the “RUN” position.
CAUTION: ALWAYS SHUT THE ENGINE OFF DURING
REFUELING PROCEDURES
Battery Volts
The outside right bar graph (4) indicates battery
voltage.
Central Display
Three liquid crystal displays (LCD) are located in the
center of the instrument cluster.
5. The top LCD is the digital transmission gear shift
position display.
6. The center LCD is the digital engine speed
display.
7. The lower LCD will display selected information as
follows:
• Tractor ground speed (MPH or km/h)
• PTO speed (rev/min)
• Engine hours accumulated (actual time)
• Service alert - as required
• Timed exit - as required
3 4
5
6
7
Section 3 - Operation
Electronic Instrument Cluster - EIC