Filter
Top Products
435/485/535
3-33
F3-42
Section 3 - Operation
Electronic Instrument Cluster - EIC
F3-41
Transmission Gear Shift Position Display
The top LCD provides a display of the gear selected.
The left figure (1) displays a letter as follows:
F - Forward gear selected*
N - Neutral selected
R - Reverse gear selected*
A - Automatic shift selected (Powershift option only)
P - Parking brake applied*
CL - Clutch depressed* (Synchromesh only)
The right figure (2) displays gear 1-12 or 1-16
depending on the transmission options.
*If the letter “P” is flashing, the display is indicating
an “Operator Prompt” where the parking brake is
inappropriately on or off or out of sequence with
the transmission control lever. To return to normal
operation, release or apply the parking brake as
appropriate. Return the transmission control lever to
neutral, release the parking brake, then shift to either
forward or reverse as desired.
NOTE: A tractor equipped with synchromesh
transmission will only display gear shift position when
moving.
Engine Speed Display
With the engine running, the digital value (3) of the
engine RPM will be displayed, together with the RPM
legend (4) in the center LCD.
The engine LCD registers in increments of 10 RPM.
If a critical engine or driveline fault should occur,
the word “STOP” will flash for 30 seconds before
automatic engine shut down occurs.
1 2
3
4