Filter
Top Products
435/485/535
3-23
F3-26
Section 3 - Operation
Cab Controls & Instruments
F3-27
F3-25
Trouble Light (Optional)
A trouble light is located in the left, rear corner
of the cab, under the rear deck. The light has a
5.5 M (18
') power cord attached. To remove the light
(1) move the locking lever (2) to the left and carefully
pull the light downward while unwinding the cable
from the holder. The light base is magnetic which
enables attachment to the tractor for convenience
while working.
The light switch (3) is a two-position switch. With the
switch lever in the off position (vertical), the light is off.
With the switch lever in the on position (horizontal),
the light will come on when the cab door is open.
The trouble light, when it is stowed in it’s cradle, is used
in conjunction with the cab dome lights to illuminate
the cab interior when the cab door is open.
NOTE: The trouble light has been designed to turn off
when the door is closed.
To stow the trouble light, reel in the cable with the
crank handle (4) inserting the pin (5) into its socket,
and lock in position with the lever (2).
Power Outlets
Three power outlets are located in the rear deck
behind the operator’s seat.
Outlet (6), 12 volt, 1-pin accessory connector.
Outlet (7), 12 volt, 3-pin accessory connection.
Outlet (8), 16-pin diagnostic connector.
Outlet (9), Cummins diagnostic connector.
Outlet (10), CAT TA22 transmission diagnostic
connector (Optional CAT TA22 Installation only)
NOTE: On earlier models a Cummins engine diagnostic
cable, BVI p/n: 86033779 is supplied with the tractor
and is located in the storage tray under the seat. This
cable connects to the 16 pin connector (8) and the
Cummins insite tool harness.
The 3-pin accessory plug (7) has 3 terminals.
Pin 1 - Key switched 12 volt power source protected
by a 20-amp fuse.
Pin 2 - Live 12 volt power source
protected by a 20-amp fuse.
Pin 3 - Ground.
4
2
1
3
5
9
8
6
2
1
3
7
10