Filter
Top Products
3-44
435/485/535
AD-9
SPEED
PTO RPM
AREA
START
STOP
CAL
DIST
% SLIP
DISTANCE
SELECT
OFF
AD-10
SPEED
PTO RPM
AREA
START
STOP
CAL
DIST
% SLIP
DISTANCE
SELECT
ON
Section 3 - Operation
EIC - Calibration
1
1
AD-8
SPEED
PTO RPM
AREA
START
STOP
% SLIP
DISTANCE
SELECT
AD-7
SPEED
PTO RPM
AREA
START
STOP
CAL
% SLIP
DISTANCE
SELECT
1
2
Entering Wheel speed calibration (Mode 20)
A 100 meter (328 ft) track is required to perform
wheel speed calibration.
1. Drive tractor to the start of the designated test
area.
2. Stop the tractor 10 m before the start line.
3. Press and hold the SELECT button (1) on the Tractor
Performance Monitor (TPM) display for 2 seconds
until TPM displays “1”.
4. Touch the UP arrow button (2) until the TPM
displays “20”.
5. Press and hold the SELECT button (1) on the TPM
for 2 seconds until TPM displays “DIST CAL 0”.
6. Select a low gear and drive the tractor forward.
7. As the tractor crosses the “Start Line” touch the
SELECT button (1) once. The TPM will display
“DIST CAL 1”
8. Continue driving until the tractor reaches the
“Finish Line”.