Filter
Top Products
435/485/535
4-17
Operation 15
Lubricate the Front Drag Link Pins
Lubricate the grease fittings (one on each side) (1)
until grease flows from around the pin seals. This will
purge any dirt accumulated in the pivot pin area.
Use Moly base grease (NLGI 1 Lithium, Moly).
Operation 16
Lubricate the Rear Drag Link Pins
Lubricate the top two grease fittings (2) remotely
mounted on the left rear frame, until grease flows
from around the pin seals. This will purge any dirt
accumulated in the pivot pin area.
Use Moly base grease (NLGI 1 Lithium, Moly).
Operation 17
Lubricate the Rear Axle Drive Shaft Steady Bearing
Lubricate the grease fitting (3) until grease flows from
the bearing area. This will purge any dirt accumulated
in this area.
Use Moly base grease (NLGI 1 Lithium, Moly).
F4-22
1
F4-21
2
F4-23
3
Section 4 - Lubrication & Maintenance
Every 10 Hours or Daily