Filter
Top Products
4-40
435/485/535
Operation 53
Change the Cab Air Filter
The cab air filter (1) located on the rear of the cab
must be changed periodically to keep the cab air
system operating at maximum efficiency.
To remove the cab air filter, unscrew the knob (2). This
will release the filter frame (3) allowing it to swing
down sufficiently to remove the filter.
Hold a light on one side of the new element and check
for ruptures. A pinpoint of light indicates a rupture
in the element paper. If this occurs, the element is
defective and must be replaced.
Install the new element into the frame and check
the seal (4) around the perimeter of the element for
nicks or cracks. Replace the element if any damage
is found.
Reinstall the filter into its frame. Lift the assembly
into place and lock in position using the knob (2).
Replacement cab air filter P/N: 86032161
NOTE: Replacement elements can be obtained from
your Buhler Versatile dealer.
WARNING: THE CAB AIR FILTER IS DESIGNED
TO REMOVE DUST FROM THE AIR BUT WILL
NOT EXCLUDE CHEMICAL VAPOR. FOLLOW THE
CHEMICAL MANUFACTURERS DIRECTIONS
REGARDING PROTECTION FROM DANGEROUS
CHEMICALS.
F4-26
F4-25
2
4
3
1
Section 4 - Lubrication & Maintenance
Every 1000 Hours