Filter
Top Products
Operation
3-5
Symbol Description
FWD Forward direction commanded
REV Reverse direction commanded
PRG Program Mode Selected (Steady)
Parameter Value may be changed (Blinking)
SET Drive is Stopped or running frequency being set
OV Overvoltage condition
UV Undervoltage condition
LIM Running in Torque Limit
OC Running in Overcurrent condition (Blinking)
Overcurrent Fault (Steady)
TEMP Running in Overtemperature condition (Blinking)
Overtemperature Fault (Steady)
DB Dynamic Brake circuit is active
rpm Revolutions per minute indication
Hz Frequency in Hertz
h Time in Hours
s Time in Seconds
A Output Current in Amperes
V Output Voltage in Volts
% Display is in percent of units
C Degrees Centigrade
Stop Mode
At the time of initial power up and after a Stop command the
control is in the Stop Mode and the display will show the set
output frequency of the control.
Run Mode
When a Forward or Reverse Run command is given the control
is in the Run Mode and the display will show one of several
output status values. The displayed output can be Output
Frequency, Output Current, Drive Load, or RPM. The displayed
output is selected by parameter 84-Display Options.