Filter
Top Products
Installation
2-21
Temporary Application of Power
Double check electrical and mechanical connections before
applying power to the control.
Temporarily apply power and observe that the display is on. If
this indication doesn’t occur, double check all connections and
verify input voltage. If the display still is not on, refer to the
troubleshooting table in Section 4.
Pre-Operation Check List
1) Verify jumper J19 settings.
2) Verify 21-Operating Mode setting.
3) Verify 24-Analog Command Select settings.
4) Verify 41-Accel/Decel/Coast Select settings.
5) Verify 77-External Trip Select settings.
6) Verify 82-Start Options settings.
7) Review Section 3 of this manual for more detailed
information on parameter adjustments and their affects on
motor operation.