Filter
Top Products
134
Chapter 6: Replacing Assemblies
1690A,AD-series disassembly/assembly
6 Reverse this procedure to install the chassis into the sleeve.
When reassembling, check the following:
all assemblies are properly installed before installing the chassis into the sleeve.
ensure all exposed cables are dressed properly so the sleeve does not cause any
damage to the cables.
To remove the fascia
1 Do the procedure "To remove the chassis from the sleeve".
2 Disconnect the on/off cable from the distribution board and remove the
cable from the cable clip.
3 Disengage the four tabs in the inside of the front panel that secure the
fascia to the front panel.