Filter
Top Products
122
Chapter 6: Replacing Assemblies
1680A,AD-series disassembly/assembly
To remove the PCI boards
The following PCI boards are installed on the logic analyzer motherboard:
PCI IEEE 1394 board (slot 2, closest to the CD-ROM drive)
PCI display board (slot 3)
slot covers (slot 3 and slot 4)
1 Do the procedure "To remove the chassis from the sleeve".
2 Disconnect the cable from the board to be removed:
PCI IEEE 1394 board: IEEE 1394 cable
PCI display board: video cable
3 Using a Torx T-10 screwdriver, remove one screw that secures each PCI
board to the rear panel.
4 Slide each board out the top of the chassis.
If the PCI display board is replaced, check to see if tape is covering the video
cable connector on the board. If tape covers the connector, remove the tape
before installing the PCI display board onto the motherboard.
5 Reverse this procedure to install the PCI boards.