Filter
Top Products
132
Chapter 6: Replacing Assemblies
1680A,AD-series disassembly/assembly
To remove the cable tray
Do the following steps only if the cable tray requires replacement.
If the cable tray requires replacing, then a label must also be ordered and applied
to the cable tray depending on the 1680A,AD-series instrument the cable tray is
installed on:
1680A,AD: 01680-94307
1681A,AD: 01680-94308
1682A,AD: 01680-94309
1683A,AD: 01680-94310
1 Remove the tilt stand from the bottom front feet.
2 Remove the logic analyzer cables from the cable tray
3 Using a Torx T-20 screwdriver, remove four screws that secure the cable
tray to the sleeve.
4 Reverse this procedure to install the cable tray.