Filter
Top Products
115
Chapter 6: Replacing Assemblies
1680A,AD-series disassembly/assembly
7 Reverse this procedure to install the chassis into the sleeve.
When reassembling, check the following:
all assemblies are properly installed before installing the chassis into the sleeve.
ensure all exposed cables are dressed properly so the sleeve does not cause any
damage to the cables.
To remove the acquisition board
1 Do the procedure "To remove the chassis from the sleeve".
2 Turn the chassis upside down.
3 Disconnect the IEEE 1394 cable from the acquisition board.
4 Using a Torx T-10 screwdriver, remove five screws that secure the probe
shroud to the rear panel of the logic analyzer.
5 Using a Torx T-10 screwdriver, remove one screw that secures the
acquisition board to the chassis (center of the acquisition board).