Filter
Top Products
118
Chapter 6: Replacing Assemblies
1680A,AD-series disassembly/assembly
6 Reverse this procedure to install the power supply
When installing a replacement power supply, transfer the power supply cables
and the grommet to the replacement power supply as shown:
To remove the hard disk drive
1 Do the procedure "To remove the chassis from the sleeve".
2 Using a Torx T-15 screwdriver, remove four screws that secure the hard
disk drive to the chassis.
3 Lift the hard disk drive out of the chassis.
4 Disconnect both the power cable and the data cable from the hard disk
drive.
5 Reverse this procedure to install the hard disk drive.