Filter
Top Products
Operating Instructions
153 146 95
C 9.92
Operating the attachments
Flow rate limiting for joystick
1 Key for individual flow rate limiting for each individual
joystick function
- Turn on the master switch for the working hydraulics.
With the flow rate limiting you can save the lifting or lower-
ing speed individually.
- Operated the joystick (4) until the desired speed at
the cylinder is reached, then press key (1).
This value will be stored as the maximum value and will
apply for the entire joystick stroke.
If the full volume flow is required again, proceed as follows:
- Move the joystick (4) as far as possible and press
key (1).
The full volume flow will be enabled again for the full joy-
stick stroke.
Setting key for float position button
2 Key for setting the joystick button (3) to „float posi-
tion of front lift“
- Press key (2).
The button (3) will now also be activated as float position
button for the front lift.
Two flashing LED indicators show the operating state.
NOTE
You can also activate and de-activate the float
position with the button (3).
The LED indicator (5) shows the operating state.
- To reverse the selection, press key (2) again.
3
5
4
21
Bild_C212