Filter
Top Products
Operating Instructions
153 146 87
C 9.92
Operating the attachments
Installing the articulated shafts
Only use shafts suitable and intended for the attachment.
These shafts are supplied with the attachment. The length
of the articulated shaft must be adjusted before the first
installation. In case of doubt please contact our customer
service. Observe the installation instructions for the articu-
lated shaft when installing it.
DANGER
Shut off the engine before the installation. Fit
the protective devices as specified after the
installation!
Removing attachments
- Drive the attachment to its storage place and lower it
with the front lift.
- Stop the engine, but do not turn off the ignition.
- Operate all control levers for the front lift several
times in all directions. This will relieve the pressure in
the hydraulic system .
- Slide the outer ring of the hydraulic couplings (1) back
and disconnect the hydraulic hoses (2).
- Close the protective caps on the hydraulic couplings
(as for item 4).
- Remove the upper link from the pin of the upper link
bracket.
- Pull the quick detach couplings (3) up to release the
attachment pins.
- Lower the front lift and back away carefully.
Bild_C267
4 2
3
1
Bild_C992H_032