Filter
Top Products
C 9.92
Operating Instructions
Maintenance after the first 50 service hours
168
Checking the coolant level, topping up if
necessary
- Park the tractor on a level surface.
- Raise the dumping subframe and secure it against
accidental lowering.
- Turn off the engine and allow it to cool.
The coolant level should be between the min. and max. marks
on the expansion reservoir (4) when the engine is cool.
Add coolant if the coolant level is below the min. mark.
ATTENTION
Do not remove the cap when the engine is
hot. Danger of scalding!
- Remove the cap (3) on the expansion reservoir (4)
and add coolant.
Observe the mixing ratio of anti-freeze/cooling water.
- Refit the cap (3).
If there is no more coolant in the expansion reservoir, the
radiator (2) must first be filled fully with coolant.
ATTENTION
Do not remove the cap when the engine is
hot. Danger of scalding!
- Remove the cap (1) and top up the radiator (2) with
coolant.
- Refit the cap (1).
- Remove the cap (3) of the expansion reservoir (4) and
fill coolant up to the max. mark.
- Refit the cap (3).
- Check the coolant level again, adding coolant if
necessary.
- Lower the dumping subframe.
Bild_S 990_034
1 2
3
4