Filter
Top Products
9-68 Command Reference
:MEASure [:VOLT] :PTPeak? PM6680B PM6681
[8 (@«1|2»)].
Peak-to-Peak Voltage
This command make measures the peak-to-peak voltage with the input DC cou
-
pled.
Parameters:
(@«1|2») is the channel to measure on
(@1) means input A
(@2) means input B
Complies to standards: SCPI 1991.0, confirmed.
:MEASure :RISE :TIME? PM6680B PM6681
[8 [<lower threshold> [,<upper threshold>[,<expected value>[,<resolution>]]]] [,(@1)]
Rise-time
The transition time from 10% to 90% of the signal amplitude is measured.The
measurement is always a single measurement and the Auto-trigger is always on,
setting the trigger levels to 10% and 90 % of the amplitude. If you need an aver
-
age transition time measurement or other trigger levels, use the :SENSe subsys
-
tem and manually set trigger levels instead.
Parameters:
<lower threshold>, <upper threshold>, <expected value> and <resolution are all ignored by
the counter
<(@1)> is the channel to measure on, i.e., input A
Complies to standards: SCPI 1991.0, confirmed.