Filter
Top Products
A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03
© 2003 Alamo Group Inc.
Section 5 - 8
Frame Rail Installation 4 WD
Frame Rail
Bar Mounting Strap
Wleded to Frame
Approx 1/2"
from end of
frame rail
Frame
Rail
Machete High Frame
Front
Support
Mount
Mounting Angle / Mounting
Tube Bolts & Nuts
Mounting Tube
Bar Mounting Straps
with Bolts & Nuts
Mount
Plate
Bolts
Figure 26
Re-Install High Frame to Tractor: (continued)
9. Frame Mount should look like. Shown below is basically what the High Frame should look like when
assembled (See Figure 26).
10.Tie Hoses to Tractor Frame Rail. Use Plastic
Wire Ties to tie the Hoses and Cables from the
rear of the Tractor down Frame Rails. Note:
below it is shown with the Frame Rails not
mounted to Tractor, this is done for illustration
only (See Figure 27).
Inspect all the Hoses, Wire harness and
Cables to make sure they are secured and will not
be rubbed or chaffed on anything. Hoses and
Wire harness should not be hanging down where
they will be caught on anything. If there is excess
length in hoses or wire harness, gather this ex-
cess up under cab and secure it out of the way.
There will most likely be excess length in these
hoses and wire harness.
Figure 27
Tank
Mounting
Tubes