Filter
Top Products
A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03
© 2003 Alamo Group Inc.
Section 4 - 14
Frame Rail Installation
Figure 29
Pre-Installing High Frame: (continued)
7. Align High frame to Frame Rails. The
High Frame Vertical Tube should be as directly
above the Vertical tube of the frame rails as
possible (See Figure 30). The illustrations in
figure 30 shows the High Frame not directly
over the Frame Rail Vertical Tube, try to get it
as directly over it as you can.
The height of the High frame should be
no higher than the Cab of the Tractor. The
horizontal tube of the High Frame should be
just above the height of the horizontal Tube of
the Frame Rail (See Figure 29 & 30)
Clamp the High frame to the Frame
Rail when aligned and leveled. (See Figure
29). Leave the Hoist connected to the High
frame for safety and additional support.
Frame Rail
Vertical Tube
Machete High Frame
Vertical Tube
Front
Support
Mount
Support
Plate
Set High
Frame in
Line with
Frame Rail
Vertical Tube
as shown
Frame Rail
Horizontal Tube
Frame Rail leading to rear
Axle Housing of Tractor
High Frame
Horizontal Tube
Figure 30
8. Re-check all alignment points. Re-check the alignment of the Frame Rails and High
Frame for level mounting position. These components must be aligned now before any Tack
welding begins.
Frame Rail Tube & Frame Rail must be align
parallel with each other up and down here