Filter
Top Products
© 2003 Alamo Group Inc.
Section 10 - 3
A-Boom (JD6615 / 7615 Asy Instruction Manual) 07/03
Attaching Flail Head:
1. With a Forklift or Hoist, lower the boom Weldment on the Flail Head. Align the boom Weldment
with the Mower Head Hitch Post. Insert special bolts (item 1 p/n 02956972 and item 2 p/n 00752405)
into Boom Weldment and Hitch Post. Attach nuts (item 3 p/n 02030300 and item 4 p/n 00037200) to
bolt and tighten securely. Note: Additional support may be needed at the end of the Boom to aid in
installation.
2. Install Hoses Female - JX in position as shown, hand tighten. DO NOT start Tractor untill
after filling Hyd Tank with Oil (See Filling Hyd Tank Section). Fully extend and retract tilt cylinder and
insure hoses do not bind or kink then secure fittings. Tighten any leaking Hydraulic Fittings. If fluid still
leaks, loosen the fitting, apply a pipe thread compound to the end threads and tighten (Do not allow
Thread compond to get into Hydraulic system). Care must be taken when tightening, over tightening
can cause the fittings to crack and require replacement fittings. Use recommened hose end and
torque values found in chart in operators manual.
3. Warning, Escaping fluid under pressure can penetrate the skin causing serious injury. Re-
lieve pressure before unhooking hydraulic or other lines. Tighten all connections before applying
pressure. Keep hands and body away from pinholes and mozzles which eject fluids under high
pressure. Use a piece of cardboard to search for leaks. If any fluid under pressure is injected into the
skin, it must be surgically removed withing a few hours by a doctor familiar with this type injury or
gangrene may result.
4. Hoses should not interfere with mower operation such as being pinched, kinked or entering
the cutter housing. The hoses may be twisted slightly. To hold them up and/or inward tighten the
fitting once the proper location is found.
* Note the position of hoses and fittings. It is important that they are installed as shown.
Optional Mower Head Installation
02961074
View "A"
View "A"
02961074
15 deg.
45 deg.
Boom
02961074
02961074
Boom
Female - JX & Male
JX90 deg. Elbow
# 02960407
Figure 4