Filter
Top Products
© 2003 Alamo Group Inc.
Section 4 - 19
A-Boom(JD 6615/ 7615 Asy Instruction Manual) 07/03
Frame Rail Installation
Tack Welding Frame Rails: (continued)
6. Tack Weld Front and Rear Angle
Mounts. The Angle Mounts should be tack
Welded to the Frame Rails in 4 places each.
This works best by weld a tack Weld in each
corner of Angle Mount. (See Figure 40 &
41). All 4 of the Angle Mounts must be Tack
Welded to frame rail now.
7. Tack Weld Mounting Tubes to High
Frame. The Mounting tubes will be Tack
Welded to the High Frame in 3 places on top
and 3 places on the bottom, on both LH & RH
Side (See Figure 42 & 43). These Tack
Welds need to be done in an alternating
pattern so Mounting Tubes do not Lift or
move. There should not be any gaps be-
tween Frame Rails, High Frame or Mounting
Tubes. Do this on LH and RH Frames.
Figure 40
Tack Weld Here
to Frame Rail
Tack Weld Mounting Tube Here
in 6 places 3 top & 3 bottom
Machete High Frame
Frame
Rail
Machete High Frame
Front
Support
Mount
Mounting Angle
w/ Bolts & Nuts
Mounting Tube
Bar Mounting Straps
with Bolts & Nuts
Set High
Frame in
Line with
Frame Rail
Approx 1/2
from end
Figure 41
Tack Weld in 4
Corners of Angle
Mounts