Filter
Top Products
A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03
© 2003 Alamo Group Inc.
Section 4 - 10
Frame Rail Installation
Pre-Installing Frame Rails: (continued)
7. Installing Frame Rails. Using a Hoist,
lift the frame rail and slide it into place under the
right rear Axle. Hold the frame rails as shown to
prevent it from moving (See Figure 13). Using
a Floor Jack (See Figure 14) support the
Frame Rail up under the Axle. Note: the RH and
LH Frame rail will install the same so you can
work either side first.
8. Install first Frame Rail to Tractor &
Rear Axle. The Frame Rails Mount to the rear
Axle of Tractor. The RH Side has Longer Bolts
than the LH Side does. This is because the Axle
Mounted Boom Rest will also mount here using
some of the same Bolts. For now use shorter
Bolts to hold Frame Rail up to Axle while you
finish the Pre-Installation. The Bolts that were
removed from the Tractor when you mounted
the Front Frame Rail Supports will work well for
this (See Figure 15).
9. Install the other Frame Rail. The other
frame rail will install the same as the first did.
DO NOT do any welding at this time.
10. Frame Stabilizer Kit. Locate the Frame
Stabilizer Kit (See Figure 16). This should be
bolted together as shown, for fitting under
tractor and to Frame rails it must be bolted
together.
Rear Axle
Mount
Figure 15
Figure 13
Figure 16
Figure 7
Floor Jack and
Frame Rail
Figure 14
Use Extreme caution so
that Frame Rail will not hit
Cab or Hood & cause
damage