Filter
Top Products
A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03
© 2003 Alamo Group Inc.
Section 4 - 16
Frame Rail Installation
10. Install Front Angle Mount. Loosely
bolt the Front Angle Mount on the other end
(front) of each Mounting Tube (See Figure
33). Notice the washer that is installed be-
tween the Angle Mount and Mount Tube, This
is there because about a 1/16" Gap is needed
between the Mount Tube Plate and the Angle
Mount Plate. Putting this 1/8" thick washer on
the front Angle Mount end only will allow for
this Gap on both ends. (See Figure 33 & 34)
This should be done on right hand and left
hand side Mounting Tube. This Gap allows
the High Frame with the Mounting Tubes
welded onto it, to be lowered down between
the front and rear Angle Mount, which will be
welded to the Frame rails later. Do not do any
tack welding till instructed to.
Pre-Install Mounting Tubes for High Frame: (continued)
Figure 33
Washer 1/8" thich inserted
between Plates on Front
Angle Mount end Only
Angle Mount
Frame Rail
Approx. 1/2"
from end
Frame
Rail
Machete High Frame
Front
Support
Mount
Mounting Angle
w/ Bolts & Nuts
Mounting Tube
Bar Mounting Straps
with Bolts & Nuts
Set High
Frame in
Line with
Frame Rail
Figure 34
Put a Spacer
Washer Here