Filter
Top Products
Command Descriptions
Syntax and Commands
2Ć108
*LRN? (Query Only)
Returns a string listing the oscilloscope settings, except for configuration
information for the calibration values. You can use this string to return the
oscilloscope to the state it was in when you sent *LRN?.
Miscellaneous
HEADer, SET?, VERBose
*LRN?
*LRN ?
NOTE
*LRN? always returns a string including command headers, regardĆ
less of the setting of the HEADer command. This is because the
returned string is intended to be sent back to the oscilloscope as a
command string. The VERBose command can still be used normally
to specify whether the returned headers should be abbreviated.
*LRN?
a partial response might look like this:
:ACQUIRE:STATE 1;MODE SAMPLE;NUMENV 10;NUMAVG
16;STOPAFTER RUNSTOP;COUNT 1;:HEADER 1;:VERBOSE
1;:CURSOR:FUNCTION OFF;VBARS:UNITS SECONDS;POSITION1
1.00E–6;POSITION2 9.00E–6;SELECT CURSOR1;
MATH1? (Query Only)
Returns the definition for the math waveform.
Vertical
MATH1?
MATH1
?
Group:
Related Commands:
Syntax:
Examples:
Group:
Syntax: