Filter
Top Products
Table 1 l-2
Fig. 11-11
NOTE 1: Measure the resistance of each coil winding while the diode and each resistor are disconnected with the/r solder
removed.
NOTE 2: If the circuit tester is not sufficiently accurate, it may not show the values given and may give erroneous read-
mngs.
Erroneous -eadings will also occur when there is a wide variation of resrstance among coil windings or v/hen measurement
is performed at ambient temperatures different from the values specified in the space directly below the table.
11-4 IGNITION COIL
[APPROX 162:
I
Resistance value
Measurement location
0.61’1
B~tl::ee? The con-e and the gree? cord
7.52
Betkseen the grew cord and the high-ttvsor cord
Table 7 7 -3
- 29 -